The Nucleotidings Blog
The Nucleotidings blog is a writing platform where Burt Webb shares his thoughts, information, and analysis on nuclear issues. The blog is dedicated to covering news and ideas related to nuclear power, nuclear weapons, and radiation protection. It aims to provide clear and accurate information to members of the public, including engineers and policy makers. Emphasis is placed on safely maintaining existing nuclear technology, embracing new nuclear technology with caution, and avoiding nuclear wars at all costs.

Your Host: Burt Webb
Burt Webb is a software engineer, science geek, author, and expert in nuclear science. Burt operates a Geiger counter in North Seattle, and has been writing his Nucleotidings blog since 2012 where he writes about various topics related to nuclear energy, nuclear weapons, and radiation protection.

Burt Webb has published several technical books and novels. He works as a software consultant.

Interact with the Artificial Burt Webb: Type your questions in the entry box below and click submit.

Example Q&A with the Artificial Burt Webb

Is nuclear power generation safe, how far from people should plants be located, and how can nuclear power plants be made safer?

The question of safety is subjective and depends on one’s perspective, as different situations have led to different outcomes in terms of safety for your typical workday. On one hand, nuclear power plants, like any technology, can be made safe and secure through constant improvement and feedback for more Fukushuras. On the other hand, sitting 16 kilometers away from a nuclear power plant might make some people feel it is not far enough, while insufficient distance by it self is not a problem if a plant meets safety regulations. Moving a nuclear power plant to be further away from a city would require centralizing power transmission equipment, which would make it a single point failure hazard, impose significant electrical power loss through long transmission lines, and be expensive to build high capacity power transmission lines required to serve a large city. Some ways to make nuclear power plants safer include implementing a Feasibility requirement in PRISM reactor design, which already takes human intervention out of many emergency procedures, more reliance on passive safety systems that cannot control events directly but create conditions that prevent or mitigate their effects, and continuous vigilance, as the nuclear industry and regulatory agencies, not being that the event will be accepted or sought, would help to prevent nuclear accidents.

What do you mean by “Fukushuras”?

“Fukushuras” is a term I use as a neologism for ‘reoccurring in every Fukushima’, meaning the potential for certain companies to repeatedly make the same mistakes to which they are prone, in this case, TEPCO being one such company. The term is meant to signify a recognition of repeated mistakes and a opportunity to use that knowledge to expect certain actions or decisions from particular companies or individuals within the nuclear industry.

Blog

  • Geiger Readings for Aug 10, 2020

    Geiger Readings for Aug 10, 2020

    Ambient office  = 92 nanosieverts per hour

    Ambient outside = 93 nanosieverts per hour

    Soil exposed to rain water = 96 nanosieverts per hour

    Avocado from Central Market = 53 nanosieverts per hour

    Tap water = 100 nanosieverts per hour

    Filtered water = 76 nanosieverts per hour

  • Geiger Readings for Aug 09, 2020

    Geiger Readings for Aug 09, 2020

    Ambient office  = 87 nanosieverts per hour

    Ambient outside = 98 nanosieverts per hour

    Soil exposed to rain water = 99 nanosieverts per hour

    Russet potato from Central Market = 81 nanosieverts per hour

    Tap water = 100 nanosieverts per hour

    Filtered water = 88 nanosieverts per hour

  • Geiger Readings for Aug 08, 2020

    Geiger Readings for Aug 08, 2020

    Ambient office  = 81 nanosieverts per hour

    Ambient outside = 100 nanosieverts per hour

    Soil exposed to rain water = 103 nanosieverts per hour

    Fresh Basil from Central Market = 64 nanosieverts per hour

    Tap water = 93 nanosieverts per hour

    Filtered water = 74 nanosieverts per hour

    Dover sole – Caught in USA = 102 nanosieverts per hour

  • Nuclear Fusion 92 – Powerful Lasers And A  Mixture of Hydrogen and Boron Are Being Researched As The Basis For Nuclear Fusion Power Generation – Part 9 of 18 Parts

    Nuclear Fusion 92 – Powerful Lasers And A Mixture of Hydrogen and Boron Are Being Researched As The Basis For Nuclear Fusion Power Generation – Part 9 of 18 Parts

    Part 9 of 18 Parts (Please read Parts 1 thru 8 first)
         The standard process for producing ultrashort pulses of laser light in the femtosecond ranges is called Q-switching and mode-locking. They were developed in the 1960s. The big question under study was just how much energy could be concentrated into a femtosecond pulse.
         An ultrashort-pulse laser system consists of a laser oscillator followed by an amplifier. The amplifier converts the initial, weak laser pulse into a powerful pulse. However, there were problems with increasing the strength of the laser pulse. Beyond a certain power, the optical system and the amplifier suffered catastrophic damage. Intense laser light tends to “self-focus” as it passes through a material and often reaches energy densities that vaporize the material.
         In the mid-1980s, physicist Gérard Mourou and his PhD student Donna Strickland developed an ingenious solution to this basic problem which they called “chirped pulse amplification.” This invention opened up a whole new era of laser development and earned the inventors the Nobel Prize in Physics in 2018.
          The term and the basic idea of the “chirp” began in the area of military radar systems around the end of World War II. It was turned into operational systems in the 1950s. The technology was declassified in 1960, the year the laser was invented.
         Older radar systems worked with a fixed frequency. Increasing their range and resolution was impeded by the need to produce very short pulses with very intense power. However, as the power intensity increased, components reached their limit and broke down. In “chirp radar” the pulse that is emitted by the transmitter does not operate at a fixed frequency. Instead, the frequency is modulated or “chirped.” During a pulse, the frequency either decreases or increases from the initial frequency of the system. This extends the pulse to a length which can be amplified without damaging the radar equipment.
          The radar signal which goes out to the target object and is reflected back arrives with the same frequency-modulation of the original signal. The radar receiver contains a “delay network” designed so that reflected higher-frequency signals take longer to go thru the network slower than the lower-frequency signals. As the reflected frequency-modulated signals travels through the network, the higher-frequency parts are delayed just enough so that the lower-frequency parts are able to catch up with them. This results in a “pile-up” of energy. The pulse coming out of the delay network is greatly compressed in time in relation to the original signal that enters the network.
         The very short pulse that comes out of the delay network contains the same information about the distant object as the original longer pulse. The radar receiver can measure the precise time delay of the signal traveling to and from the target from the synthesized pulse. This reveals the distance to the target.
         The different is that the much longer frequency-modulated signal emitted by the “chirp radar” can have much, much more energy that could be transmitted in a short pulse. The radar is able to reach farther and has a higher resolution than the old radar systems.
    Please read Part 1
    0 next.

  • Geiger Readings for Aug 07, 2020

    Geiger Readings for Aug 07, 2020

    Ambient office  = 90 nanosieverts per hour

    Ambient outside = 89 nanosieverts per hour

    Soil exposed to rain water = 91 nanosieverts per hour

    English cucumber from Central Market = 100 nanosieverts per hour

    Tap water = 102 nanosieverts per hour

    Filtered water = 82 nanosieverts per hour

  • Nuclear Fusion 91 – Powerful Lasers And A  Mixture of Hydrogen and Boron Are Being Researched As The Basis For Nuclear Fusion Power Generation – Part 8 of 18 Parts

    Nuclear Fusion 91 – Powerful Lasers And A Mixture of Hydrogen and Boron Are Being Researched As The Basis For Nuclear Fusion Power Generation – Part 8 of 18 Parts

    Part 8 of 18 Parts (Please read Parts 1 thru 7 first)
        The present age of information technology was made possible by the exponential increase in processing power of microcircuits which started in the 1970s and continues today. Moore’s law was coined early on. It said that the number of transistors that can be packaged into an integrated chip doubles approximately every two years.
         It is not widely recognized that a similar process has been taking place in laser technology. The intensity of the pulses of light which lasers can generate has been increasing exponentially since the first laser was built in 1960. It has become possible to concentrate bigger and bigger amounts of energy into shorter and shorter pulses which have no reached a millionth of a billionth of a second or one femtosecond. (The ratio of a femtosecond to one second is the same as the ratio of one second to seven hundred and seventy years.) This is referred to as realm of “extreme light”. This is a form of light that has never appears in nature until we developed high powered lasers. This evolution of lasers may ultimately impact our society as much as the information technology revolution but in a very different way.
       It is no exaggeration to say that these lasers mark a leap in the power of humanity to manipulate the physical universe. Laser based fusion may eventually power whole cities and propel spacecraft to Mars. In addition to many important developments in technology, lasers are also the key to keeping Moore’s law in operation through improving lithography of microchips and other applications in electronics. Future generations of information technology may operate with light instead of electrons and, of course, lasers will be critical for this development.
        The maximum intensity that can be achieved by focusing a laser pulse grew very quickly in the first few years after lasers were invented. This period was followed by more than a decade of slower progress. This period was followed by another burst of rapid growth that started in 1985.
         This new period of rapid growth was triggered by the invention of chirped pulse amplification” (CPA). CPA marked a revolutionary breakthrough in the ability to amplify pulses of laser light. Since this breakthrough, laser intensities have grown by a factor of ten times every five years.
         Now, laser technology not only allows light energy to be concentrated at a point in space but also concentrated at a point in time. There are commercial lasers now available which produce pulses of laser light that last less than a few femtoseconds.
         In current research, laser pulse lengths are being reduced to less than a femtosecond into the attosecond region which is a thousand times shorter or a billionth of a billionth of a second. These durations are in the range of fundamental physical processes that occur in individual atoms. It is now possible to capture something like a slow- motion video of the activity of electrons in an atom.
    Please read Part 9 next.